Skip to main content

FOUR-COLUMN HYDRAULIC PRESS FOR STAMPING, DRAWING, PUNCHING, AND DEBURRING WORK

The MV-600E/NC four-column hydraulic press belongs to the M/NC series and is custom-designed to achieve greater precision and capacity, specifically manufactured for stamping, deep drawing, punching, and deburring tasks.

Equipped with a top and bottom table made of C45E steel, machined with DIN-650 slots, and a removable upper counter-table of 990 x 890 x 130 mm for die holders with “T” slots. We ensure minimal friction in the vertical movement of the top table through the installation of maintenance-free bimetallic bushings, with perfect parallelism achieved by four chromed and ground cylindrical columns.

It uses an optimized hydraulic system with a pressure of 320 Bar, ensuring prolonged durability and reliability in its performance.

It meets and satisfies all essential safety and health requirements according to CE regulations.

MORE INFORMATION

STRUCTURE AND TABLES

Consists of three electrowelded blocks made exclusively of S355JR steel.

  • Stabilized and machined at the end of the welding process to ensure perfect parallelism and precision.
  • Calculated and designed using finite element software.

CYLINDER AND HYDRAULIC GROUP

  • Double-acting cylinder with lapped sleeve, chromed piston, and maintenance-free anti-wear guides.
  • Motorized hydraulic group with two speeds and automatic disconnection of fast speed. High-pressure pump and 10-micron return filter. Includes cylinder decompression valve, directional valve, and safety valve. A pressure switch located on the side allows the most appropriate pressure setting for each type of work.
  • Glycerin manometer with reading in tons.

ELECTRICAL INSTALLATION AND SAFETY

  • Incorporates a SIEMENS SIMATIC S7 1200 PLC and a 7” HMI KTP-700 touch panel. This allows programming of the power, cylinder stroke, and speeds, with a storage capacity of 300 memories for different work cycles.
  • The electrical panel incorporates a selector to choose manual, semi-automatic, or automatic operation modes, and another selector for fast or slow speed operation.
  • Equipped with a PLC to internally assist with maneuvers and decompression time.
  • Operation is carried out using a low-voltage electric two-hand button panel.
  • Electrical and hydraulic maneuvers are redundant and self-controlled, incorporating an additional safety block and self-control devices for maneuvering and safety. Includes verification and certification of proper operation and safety distance for photocells.
  • For safety, category IV photoelectric barriers are incorporated in the front work area, two fixed side protections, and a movable protection with a magnetic disconnection detector at the rear.
  • Machine equipped with an IXON system for online communication in case of faults or reprogramming.
  • Ladder with upper walkway for repair access (scaffold).

TECHNICAL SPECIFICATIONS

MODEL MV-600E/NC
Power tn 600
Motor Power 40 HP a 440 Vca / 60hz
Working Speed mm/s 5
Approach Speed mm/s 15
Return Speed mm/s 18
Piston Stroke mm 1.015 mm – (40”)
Guide Diameter mm 200
Table Usable Area mm 990 x 890 x 130

(39” x 35” x 5”)

Between Columns mm 990 x 370
Vertical Clearance mm 1.625 – (64”)
Working Height mm 990 – (39”)
Lower Hydraulic Knockout Tn 80
Lower Knockout Stroke mm 406.4 – (16”)
Upper Hydraulic Knockout Tn 80
Upper Knockout Stroke mm 406.4 – (16”)
Total Frontal mm 1.850
Total Lateral mm 1.700
Total Height mm 4.500
Weight Kg. 23.000 Kg. approx.

    Ask for Information